hydroproof – economical water based acrylic waterproofer with abe membrane

by | Jul 30, 2015

hydroproof® is an economical, water-based acrylic waterproofer – used with abe® membrane

    Uses:

    • For waterproofing all types of stable flashings
    • For waterproofing parapet walls
    • Sealing of joints, laps and roofing screws on corrugated roofs and gutters
      Technical Datasheet
      Product Quality Guarantee
      Digital Leaflet
      Request MSDS
      Reproplast
      Advantages
      • hydroproof® is an all-in-one system
      • There is no need for separate primers on porous surfaces
      • hydroproof® has excellent weathering properties, adhesion and is tough, flexible and non-toxic
      • hydroproof® comes in a wide range of colours
      Surface Preparation

      Ensure all surfaces are clean dry, sound and free from all laitance, fungal growth, grease, oil or loose and flaking particles.

      Bonding / Priming

      Prime porous surfaces with a neat coat of hydroproof®. Prime metal surfaces with 4 metal primer.

      Mixing

      Stir well before use.

      Coverage

      2.1 l/m2 full system.

      Application

      1st coat (after priming):

      Apply by brush/roller using 1L/m2. Embed abe® membrane into wet coat, avoiding bubbles or wrinkles. Membrane overlaps minimum 100mm on end laps and 75mm on side laps.

      2nd coat: once 1st coat has dried (2 – 3 hours), apply 2nd coat by brush/roller using 0,5L/m2 and ensure membrane is fully saturated.

      3rd coat: once 2nd coat has dried, apply 3rd coat at different angle to 2nd coat using 0,5L/m2 .

      Drying time @ 25 ºC

      • Touch dry: 1 hour
      • Hard dry: 24 hours
      • Full cure: 7 days
      Cleaning of Equipment

      Whilst still wet, clean equipment with water. If hydroproof® has dried use abe® super brush cleaner followed by washing with soap & water.

      Caution

      Membrane must be used.

      Always ensure that hydroproof® is applied to well drained roofs.

      Protection on Completion

      Whilst hydroproof® is designed for an extended life, it is important to apply a maintenance coat of hydroproof® every 3 to 4 years.

      Packaging

      Available in 5 liter.

      Colours

      Red, grey, charcoal, burgundy, white, green, brown and terracotta.

      Important Note

      This data sheet is issued as a guide to the use of the product(s) concerned. Whilst a.b.e.® endeavours to ensure that any advice, recommendation,
      specification or information is accurate and correct, the company cannot accept any liability for application – because a.b.e.® has no direct or
      continuous control over where and how a.b.e.® products are applied.

      Further Information

      Where other products are to be used in conjunction with this material, the relevant technical data sheets should be consulted to determine total requirements. 

      a.b.e.® has a wealth of technical and practical experience built up over years in the company’s pursuit of excellence in building and construction technology.