duraroof

• Economical acrylic paint with waterproofing properties.
• Tough, non-toxic, water based paint for porous and non-porous surfaces.
• Offers durable, weather resistant and good adhesion on all prepared surfaces.
• Register for a 5 year quality guarantee (T&C’s apply).
• Available in a range of standard roof colours with a smooth finish.

Ensure all surfaces are clean dry, sound and free from all laitance, fungal growth, grease, oil or loose and flaking particles.

All surfaces (except metal) – Dilute a.b.e.^® duraroof with 10% clean water and prime total area to be covered. Allow to dry for
±30 minutes.

Metal surfaces only – Prime with a.b.e.^® 4-metal primer. This not only gives excellent adhesion but resists rust. Allow drying for 4 hours.

Stir well before use.

Spread rates are approximate subject to surface profile and porosity.
Recommended WFT: 163 microns per coat.
Theoretical spreading rate:
5 – 6 m² / L per coat on rough or absorbent surfaces.
7 – 8 m² / L per coat on smooth, non-porous surfaces.

All surfaces after priming: brush or roll on a 1st coat of a.b.e.^® duraroof and allow to dry 2 – 3 hours.
Apply the 2nd coat of a.b.e.^® duraroof and allow to hard dry for 24 hours.
Work roof sections downwards completing a tile or sheet at time.
Avoid lap marks by also keeping a wet edge during application.
Do not apply if rain is imminent.

Tools must be cleaned immediately after use and before material has set with a.b.e.^® super brush cleaner followed by washing with soap and water.

Whilst a.b.e.^® duraroof is designed for extended life, it is important to apply a maintenance coat of a.b.e.^® duraroof every 3 years.

Available in 20 L containers.

This data sheet is issued as a guide to the use of the product(s) concerned. Whilst a.b.e.^® endeavours to ensure that any advice, recommendation, specification or information is accurate and correct, the company cannot – because a.b.e.^® has no direct or continuous control over where and how a.b.e.^® products are applied – accept any liability either directly or indirectly arising from the use of a.b.e.^® products, whether or not in accordance with any advice, specification, recommendation, or information given by the company.

Where other products are to be used in conjunction with this material, the relevant technical data sheets should be consulted to determine total equirements.