epidermix 201

• Sets to a non-brittle film within 72 hours.

• Retains flexibility – does not crack readily when in service.

• Easily shaped and sanded.

• Can be used on areas subjected to fresh and seawater.

• Resists certain fuels and dilutes APPLICATION acids and alkalis.

The surface to which epidermix 201 is to be applied must be thoroughly CLEAN, mechanically SOUND, and DRY.

Self priming.

Stir each component thoroughly, then add the contents of the activator tin to the contents of the base tin and mix thoroughly with a flat metal bar or by means of a slow speed electric drill, fitted with a suitable paddle.

1 litre/m²/mm thick. Maximum thickness 25 mm.

Apply to the prepared surface with a steel trowel to the desired thickness. When used as a fairing compound, the material can be stiffened by mixing in small amounts of fumed Silica or fillite beads.

Fairing may commence after 72 hours.

Clean tools with abe^® super brush cleaner followed by rinsing with clean water. Tools must be cleaned immediately after use and before the material has been set.

Paint for UV protection after 7 days.

See properties table.

Two-component, slow curing epoxy paste used as a scraper or fairing compound.

The scraper/fairing compound shall be epidermix 201, a two component, solvent free, polyamide cured epoxy system applied in accordance with the manufacturer’s recommendations,
a.b.e.^® Construction Chemicals.

The compound shall remain flexible when fully cured.

epidermix 201 is supplied in a 2 litre kit.

Code: 20103054

This product has a shelf life of 24 months if kept in a dry cool place in the original packaging. In more extreme conditions this period might be shortened.

Uncured epidermix 201 is toxic and excessive skin contact and inhalation should be avoided. Work in well ventilated conditions. Hands should be protected with rubber gloves or suitable barrier cream.

This data sheet is issued as a guide to the use of the product(s) concerned. Whilst a.b.e.^® Construction Chemicals endeavors to ensure that any advice, recommendation, specification or information is accurate and correct, the company cannot – because a.b.e.^® has no direct or continuous control over where and how a.b.e.^® products are applied – accept any liability either directly or indirectly arising from the use of a.b.e.^® products, whether or not in accordance with any advice, specification, recommendation, or information given by the company.

Where other products are to be used in conjunction with this material, the relevant technical data sheets should be consulted to determine total requirements.